Golden Hours - Early morning at Kolar - Dehaze

Early morning view from Anthargange Caves, Kolar, Karnataka, India. This is the view after Dehaze.

Have a photo which was captured early in the morning full of fog and poor visibility or a landscape shot with lot of haze and makes the image appear dull. I had many photos of this kind and had rejected from uploading it on social media or sharing it with my friends. Not anymore as Adobe has now introduced ‘Dehaze’ slider in the latest versions , Lightroom CC and Camera Raw 9.1 for Photoshop CC.
With this new option you can either add more haze to the image by moving the slider to the left or remove most of the haze and make the image look more interesting and eye catching. Thanks to Adobe for coming up with this new slider which is really helpful and this bring many of my old images back to life which I had archived earlier because of too much haze in it.

Below is an old JPEG image that I had captured using my first camera – point and shoot – Canon Powershot SX 100 IS. I did not have a full frame DSLR at that time. This was early in the morning at around 6AM (golden hours) at Antargange caves, Kolar where I had to trek overnight and stay overnight in the open ground with my camera and a sleeping bag. Did cave exploration at night for few hours after which had slept for 1 hour and then the beautiful view of sunrise.
Dahaze in photoshop and lightroom

Note that the above image was in JPEG and not RAW format. Hence there is very less color information. I always recommend you all to capture images in RAW format. In the above case my point and shoot camera did not have the option to capture in RAW format.

The new dehaze option is in develop module and under Effects, in Lightoom. You can either move the slider to the left or right to increase haze or dehaze. In the above image you can see how it was before and how it has turned the image from dull to an interesting image. Note that the Dehaze option that we have applied to the entire image and currently you don’t have an option to dehaze to s small region.

In RAW images the noise introduced may not be visible, but in images like the above where I have used JPEG, which is a compressed image and has already lost most of the color information, a dehaze option would still work very well but may add little noise. The best practice is to edit a RAW image, set it’s white balance and then adjust the Dehaze slider to remove or add haze. If you want to move to the extreme ends of the slider then you might have to consider adjusting the basic panel as well.

Adobe has done a good job by adding dehaze slider. Hope Adobe will consider these in the next release of adding the dehaze slider to brush and graduation filter so that it gives more control while editing images and dehaze a specific region instead of entire image.

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website